What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 09:33
For this case there are devices called Metal oxide varistors (MOV).
I post the exact comment here.
The other is “what does a “fuse” do?”
An AC voltage/ current source, and an ac inductive load.
The third is lightning and “how it gets conducted into a home.”
but this device (an Inductor) … impedes the rapid changes in the current.
These devices are installed between the “hot” and “neutral” and protective ground.
This is where the MOV conducts again, and dissipated the energy.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes Rainy Season and Lightning.
Central Ohio woman battles severe form of non-alcoholic fatty liver disease - 10tv.com
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
He then asserts :
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
What is lightning?
It seems Mohan does not understand the difference between a comment and an Answer.
In schematic diagrams this is the symbol for a fuse:
Young & Restless Preview: Cane’s Agenda Revealed — ‘No More Secrets and No More Games’ - Soaps.com
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
what exactly is a ‘surge’ protector?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
eight
So, the voltage could go up to 500 volts, and the fuse will not open up.
nine
The bolt then partially travels down the line to your home.
He then describes the function of a fuse.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Because the load is inductive, the current lags the voltage.(by a bit).
This device then solves the entire problem.
(Dc diagram shown, AC is similar).
[old diagram got deleted by accident]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Here is a simplified AC power diagram.
First Sentence:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
What causes my mouth to be so dry at night my teeth sticks to my lips?
At least they know the answer if they wanted it.
There are three different concepts here that are getting confused.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
One
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
Barnstars:
There are two important concepts here.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
These are simplified answers to the original question, and does not change anything I wrote above.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At one ohm, the resistor has a maximum of 1 watt power.
A circuit breaker is similar, but is resettable.
A fuse is a non-resetable over current circuit protector.
but I think this circuit , shows a few more pieces.
This one hit behind the barn.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is 'the assistant's answer'
Edit 2024–10.
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
One is “what exactly is in a ‘surge protector’ ? ”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
But it can get overloaded, and no longer works.
so, what happens?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
a photo is worth a thousand words.
It also is a device that limits the change in current flow.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–10[John johnson John Johnson ]
Upvotes:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.